![]() To obtain the net volume of liquid at 15 ☌, multiply the uncompensated meter reading by the volume correction factor (VCF) which corresponds to the average measured temperature of the liquid during the delivery. for the Use of the Joint API and ASTM Adjunct for Temperature and Pressure Volume Correction Factors for Generalized Crude Oils, Refined Products, and Lubricating Oils: API MPMS Chapter 11.1 Version. Also shown in Table 1 are the limits converted to their equival. Values calculated as per ASTM-IP Table 54 (1986) Table 1 shows the defining limits and their associated units in bold italics. Volume correction factors to 15 ☌ for use with liquefied petroleum gas or propane at 510 kg/m 3 Temperature ☌ This correction is normally referred to as Ctl. This table shows the correction for the effects of temperature on the liquid. According to ASTM D396-21, there are the following fuel oil grades: No. Fuel oils are used primarily for space heating and electric power generation. ASTM D396-21: Standard Specification for Fuel Oils sets various grades of fuel oil. ![]() Refer to bulletin V-18 for more information on product classes. Second is distillate fuel oil, in the form of diesel fuel and fuel oils. Please consult the API or other suitable sources for other uses.ĭensity at 15 ☌ = 510 kg/m 3 (derived from table ASTM-IP 54, 1986) These tables are intended for inspection purposes only and may not be suitable in determining corrections for trade transactions of bulk commodities. The copy of this document located on Measurement Canada’s website is considered to be the controlled copy. TABLES GRADE TEMPERATURE DENSITY 15C DENSITY air SPECIFIC GRAVITY 60F T11 - (LT/Bbls) T13 - (MT/Bbls) T52 - (M3/Bbls) NILE BLEND CRUDE OIL 0.8722.
0 Comments
Leave a Reply. |